Cisco 9800-40 RRM Reset Command

[Jay233]

Hi All,

Just in the middle of deploying 400+ 9120axi AP's into a large building, migration will be over several weeks. 

From past experience on older controllers I always reset RRM globally when all new AP's are operational.   

Restart the RRM DCA process on the RF Group Leader. From the WLC, enter the below commands:

2.4 GHz: #config 802.11b channel global restart

5 GHz: #config 802.11a Chanel global restart

What is the command for the 9800's or best process ?

Cheers,

[balaji.bandi]

check the Cat 9800 command syntax :

https://www.cisco.com/c/en/us/products/collateral/wireless/catalyst-9800-series-wireless-controllers/guide-c07-743627.html

https://www.cisco.com/c/en/us/td/docs/wireless/controller/9800/config-guide/b_wl_16_10_cg/radio-resource-management.html

[Rich R]

https://www.cisco.com/c/en/us/products/collateral/wireless/catalyst-9800-series-wireless-controllers/guide-c07-743627.html#DCArestart

[Ben Crissman]

ap dot11 {24ghz | 5ghz | 6ghz} rrm dca restart