Cisco Access Point 9130AXE CLI unusual Language

[Rahul Kapadia]

I've reset Cisco AP 9130AXE which was in EWC mode and now CLI shows some unusual languages.

j▒ĥk9▒9')▒▒9▒▒▒1/▒▒▒((I▒!q▒99▒H!▒7 H▒01w((I▒▒!▒1▒▒▒91▒91▒ ܖ▒H((Z((▒▒▒1▒H9▒▒▒1▒▒19▒ň1▒▒7▒▒79▒▒79▒▒H▒yI▒!)▒▒▒1▒)ͥy▒H▒▒▒!q9▒!9{穵9!!▒▒11▒(▒▒)▒▒▒9▒▒▒▒▒▒▒▒▒▒▒!▒▒!{q!!▒

Is there any other solution to reset it and solve this language issue?

[Kasun Bandara]

@Rahul Kapadia hi, is this from SSH or console? if its Console try correct baud rate 9600. also if you using usb console converter, make sure your drivers are properly installed in PC or try another converter. 

[Rahul Kapadia]

Kasun,

I am using console and baud is already set to 9600. There is no USB converted console.

[Leo Laohoo · Accepted solution]

If the AP is on 17.12.X (and later), set the baud rate to 115200.

[Rahul Kapadia]

Leo,

Thanks, 115200 worked.

[Rich R]

FYI: this change was introduced by https://bst.cisco.com/bugsearch/bug/CSCwe88390

This is documented in https://www.cisco.com/c/en/us/td/docs/wireless/controller/9800/technical-reference/c9800-best-practices.html#AccessPointConsoleBaudRate so it's a good idea to go through that Best Practices guide.