cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1719
Views
0
Helpful
4
Replies

Cisco Access Point Autonomous mode with tcp port 37540 open

CartoGraph
Level 1
Level 1

Hello All,

 

I have two Access Points and I discovered that one of them has the 37540 port open.

 

1) It is possible to turn if off ? If yes, how?

2) How this affects the AccessPoint clients?

 

Thank You.

4 Replies 4

As per the below document that port number is used when  AP configured as Spectrum Expert (SE-Connect mode)

https://www.cisco.com/c/en/us/support/docs/wireless/5500-series-wireless-controllers/113344-cuwn-ppm.html

 

If you check your AP config, you can revert it back to normal autonomous AP

 

HTH

Rasika

*** Pls rate all useful responses ***