12-20-2020 06:42 PM - edited 07-05-2021 12:55 PM
I am having Cisco AP model AIR-AP1852I-Q-K9
I am going to run debug & capture the logs as per the below manual.
According to the manual, the below file is going to be created.
# debug traffic wired ip capture % Writing packets to "/tmp/pcap/2802_capture.pcap0" #reading
from file /dev/click_wired_log, link-type EN10MB (Ethernet)
Question is how can i check the file in /tmp
Is there any way i can access the path /tmp ?
If so how to access it ?
12-20-2020 10:31 PM
Once you SSH into AP, then you should be able to see those directory / file paths.
HTH
Rasika
12-20-2020 10:37 PM
thanks.
I have done SSH to AP. I am in #prompt.
From here how to check it ?
12-20-2020 10:57 PM
"show flash" should tell the file system in flash.
Rasika
12-21-2020 09:37 PM
show flash show the directory as /storage
I dunno where is /tmp
12-22-2020 12:07 PM
Once you issue that "debug traffic wired ip capture" it should automatically write it to /temp/pcap/xxx path. Then you should be able copy it to external TFTP
copy pcap AP70DB.98E1.3DEC_capture.pcap0 tftp 192.168.1.100
Did you try it as instructed?
HTH
Rasika
01-17-2021 06:08 PM
Thanks,
how can I browse the below path in the AP
/temp/pcap/xxx
I want to go to /temp/pcap and want to check the files stored in the below location.
How can I do that.
Also is there time limit the debug files are stored in the below location.
When I tried to retrieve the file after 3 days, it says the file does not exists.
So wanted to check what is the limit the file exists in the AP.
Will the file gets removed when the AP reboots ?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide