I am having Cisco AP model AIR-AP1852I-Q-K9
I am going to run debug & capture the logs as per the below manual.
According to the manual, the below file is going to be created.
# debug traffic wired ip capture % Writing packets to "/tmp/pcap/2802_capture.pcap0" #reading
from file /dev/click_wired_log, link-type EN10MB (Ethernet)
Question is how can i check the file in /tmp
Is there any way i can access the path /tmp ?
If so how to access it ?
Once you issue that "debug traffic wired ip capture" it should automatically write it to /temp/pcap/xxx path. Then you should be able copy it to external TFTP
copy pcap AP70DB.98E1.3DEC_capture.pcap0 tftp 192.168.1.100
Did you try it as instructed?
how can I browse the below path in the AP
I want to go to /temp/pcap and want to check the files stored in the below location.
How can I do that.
Also is there time limit the debug files are stored in the below location.
When I tried to retrieve the file after 3 days, it says the file does not exists.
So wanted to check what is the limit the file exists in the AP.
Will the file gets removed when the AP reboots ?