05-02-2011 01:04 AM - edited 07-03-2021 08:08 PM
Hello i have an Cisco ap and i can not activate channel bonding on 5Ghz Interface
I set the channel 116 in 5Ghz at 40Mhz but i says the active channel is 116 at 20Mhz (DFS enabled but)
i atached to this thread the print screens
How can i setup the channel bonding on cisco air 1252.
Thank you.
05-02-2011 02:31 AM
Does it have enough power ? (it requires more than normal poe)
Please collect "show controllers d1" on command line (telnet or whatsoever) and possibly also the console output when AP boots.
05-02-2011 03:31 AM
it is on power supply is not PoE
05-02-2011 04:26 AM
do we have all the antennas connected??
Regards
Surendra
05-02-2011 05:05 AM
i solved the problem... there is a little trick with the dfs enabled and world mode multi domain enabled... i have change the country code to JP and after this let me to set the 40 Mhz width.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide