Cisco Air-Cap 2602 no bootable files

[yevgeni22]

Hello, i have Cisco 2600 series device and it got a problem. Some one got it reset and erased all files from the boot.

Any idea what do i need to do to restore it ?? some one told me i need to get tftp server.And the cisco flashing in red light

[Flavio Miranda]

Hi

 If you run "dir" on the prompt, what do you get?

[yevgeni22]

[Flavio Miranda]

dir flash[0]: 

[yevgeni22]

unable to stat flash[0]:/: permission denied 

[Flavio Miranda]

and the command  "set"  shows what?

[yevgeni22]

DEFUALT_ROUTER=10.0.0.1

IP_ADDR=10.0.0.1

NETMASK=255.255.255.224

[Flavio Miranda]

Do you have a new IOS to put there?  If you do, try to fire up a TFTP server on your PC and try to transfer a new IOS to the AP

[yevgeni22]

That the problem i don't know how to do it

[Flavio Miranda]

But do you have an IOS to install?

[yevgeni22]

All i have is PuTTY, console cable and POE

[Flavio Miranda]

If you have the IOS to transfer to the AP, you just need to follow this guides.

https://community.cisco.com/t5/wireless-mobility-knowledge-base/access-point-rommon-recovery-ap-prompt-recovery-example/ta-p/3119495

https://www.youtube.com/watch?v=j1q-JSjyhnw

any specific doubt just ask here

[yevgeni22]

Thank you very much i will try it tomorrow.

[Flavio Miranda]

You are welcome.

Let us know.

[Haydn Andrews]

Follow this https://thewlan.com.au/2016/09/27/configuring-a-cisco-ap-for-site-survey/

up to the AP configuration part, when you get there get AP to join WLC as per normal join process

but use the light weight AP image https://software.cisco.com/download/home/286256843/type/280775090/release/15.3.3-JPO instead of the w7 image