On WLC5508 with 7.6.110.0 image, what could be the reason for MAP AIR-CAP1552SA to drop off from its RAP for 7 hours after 15 days of working?
Apparently, the MAP joined back after seven hours with following messages below. (I have obfuscated actual mac address by xx:xx.)
During the dropped period, the WLC did not receive any CAPWAP discovery/join or show any other messages from these two APs.
There is a Primary and Secondary WLC, and other APs. WLC had been up for 71+ days at that time. So, WLC or RAP were not down.
The WLC and APs are in the same country code - India domain.
WLC Image:
Product Version.................................. 7.6.110.0
Bootloader Version............................... 1.0.16
Field Recovery Image Version..................... 1.0.0
AP Image:
System image file is "flash:/c1520-k9w8-mx.152-4.JB4/c1520-k9w8-xx.152-4.JB4"
The following messages were shown:
--------------------------------------------------------------------------------------------------------------------------------------------------
*spamApTask0: Aug 05 12:29:44.546: b4:e9:b0:16:xx:xx Discovery Request from 192.168.0.201:26623
*spamApTask0: Aug 05 12:29:44.546: b4:e9:b0:16:xx:xx ApModel: AIR-CAP1552SA-N-K9
*spamApTask0: Aug 05 12:29:44.546: b4:e9:b0:16:xx:xx Join Priority Processing status = 0, Incoming Ap's Priority 4, MaxLrads = 50, joined Aps =17
*spamApTask0: Aug 05 12:29:44.546: apModel: AIR-CAP1552SA-N-K9
*spamApTask0: Aug 05 12:29:44.546: apType = 20 apModel: AIR-CAP1552SA-N-K9
*spamApTask0: Aug 05 12:29:44.546: apType: Ox14 bundleApImageVer:
*spamApTask0: Aug 05 12:29:44.546: Could not find image version of bundled AP(apType: 20)!!!
*spamApTask0: Aug 05 12:29:44.546: Unable to get AP Bundled Version. Using Controller Version!!!
*spamApTask0: Aug 05 12:29:44.546: b4:e9:b0:16:xx:xx Discovery Response sent to 192.168.0.201 port 26623
…
*apfReceiveTask: Aug 05 12:29:55.034: Split tunnel status (Disabled) encoded in the vap payload for WLAN(4), AP:b4:e9:b0:16:xx:xx (slotID 0)
*apfReceiveTask: Aug 05 12:29:55.034: b4:e9:b0:16:xx:xx Spam AP Queue is FULL !!!AP b4:e9:b0:16:xx:xx(0)
*apfReceiveTask: Aug 05 12:29:55.035: b4:e9:b0:16:xx:xx Register LWAPP event for AP b4:e9:b0:16:xx:xx slot 1
*apfReceiveTask: Aug 05 12:29:55.035: WARP IEs: (12)
-----------------------------------------------------------------------------------------------------------------------------------------------------------
The MAP has the same image as WLC, exists in the mac-filtering list, and was joined thru a RAP (CAP1552) for 15 days.
1. Why was MAP showing no image in 'bundleApImageVer: ' message above?
2. What does 'Spam AP Queue is FULL' mean? When is this message seen? I searched but this message couldn't be found in WLC error list.
There are no AP crash log on the WLC. The MAP is three hops away. All APs are already in the Mac Filtering list and on the same subnet as WLC.
Any ideas? Thanks.
-Arif
