11-21-2011 07:49 AM - edited 07-03-2021 09:06 PM
Hello good people. I have recently bought Cisco AIR CAP3502I E K9 but i am seeing that it can only work with WLAN controller. How can I make it work as a stand alone.
Your help will be appreciated.
11-21-2011 07:50 AM
Any good links on how i can start configuring it as standalone WAP
11-21-2011 07:54 AM
Take a look at this
https://supportforums.cisco.com/docs/DOC-20537
Sent from my iPhone
11-21-2011 07:51 AM
You can use the 1260 autonomous code if you want. Just remember, this isn't supported by Cisco but it will work.
Sent from my iPhone
11-21-2011 07:52 AM
U can convert but not supported by TAC!!
use the below link..
https://supportforums.cisco.com/docs/DOC-14960
Please dont forget to rate the usefull posts!!
Regards
Surendra
11-30-2011 02:45 AM
Scott whats the autonomous code 1260 for and how is it used. I have never confugured a cisco wirelsess AP
11-30-2011 04:43 AM
This information is so helpful. Last part is where can i get
cisco IOS for 1260 ap3g1-k9w7-tar.124-25d.JA1
Don have smartnet account
11-30-2011 05:33 AM
Send me an email you on that.
11-30-2011 07:09 AM
11-30-2011 11:36 PM
Team confirm that after this conversion to standalone it can pass traffic. I have read some text which say it cannot pass traffic.
11-30-2011 11:41 PM
Where did you read that? You should have no issue since the 3502 radios are the same as the 1260. You just won't have the full feature of the 3502.
Sent from Cisco Technical Support iPhone App
11-30-2011 11:44 PM
Thanks Fella.
Any document showing how to finish off the configs after the IOS chnage. The howto docs for 1260/3502 for stand alone most i am seeing are for controller based. Have never setup a cisco WAP but i understanda and am into cisco
11-30-2011 11:48 PM
You can reference this guide for the 1140
http://www.cisco.com/en/US/docs/wireless/access_point/1140/autonomous/getting_started/guide/ap1140aut_getstart.html
http://www.cisco.com/en/US/docs/wireless/access_point/12.3_7_JA/configuration/guide/s37ssid.html
http://www.cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a008055c39a.shtml
Sent from Cisco Technical Support iPhone App
11-30-2011 11:44 PM
Here is a link from George's blog page
http://www.my80211.com/home/2011/11/18/autonomous-ios-support-for-3500-and-3600-series-access-point.html
Sent from Cisco Technical Support iPhone App
12-07-2011 03:56 AM
I am still having troubles with this issue.
Scott kindly resend the image again as it should be uploaded.
Another challenges is setting the ip address go g0 interface. Even though i do that manually dhcp continues to discard the manual n gets smthing from my dhcp since it will continously look for WController.
How do i sort this out.
I have also failed to access the GUI thru the private ip add
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide