01-03-2011 07:08 AM - edited 07-03-2021 07:36 PM
hi
i have configured windows 2003 server with DNS ,Active directory users and dhcp server. and configured my cisco 1130g AP .
i have installed cisco access control server 4.0 because i use LEAP authentication protocol and for the ACS for network configuration i give aaa client ip addresss as AP interface ip and same shared secret for the AP and ACS,.
so when i log to wifi it ask username and password
problem is lap top cannot have a ip address my dhcp server not issue any ip address .
my hiper terminal massage is like this when i connect to wifi
help ...thank you...
01-06-2011 06:20 AM
You need to configure your client for the right EAP type. your client doesn't do leap on its own for example ...
Nicolas
01-06-2011 08:07 AM
i configured both my access point and ACS server in LEAP type..
is it enough..
01-06-2011 10:13 PM
As I mentioned now several times already, it is the client and ACS which do the PEAP. The Access point doesn't have to be configured for an eap type. What you did on the AP was setting the AP as a radius server which is duplicate work with what you did on ACS.
So you need on your client to configure either PEAP or LEAP.
Nicolas
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide