04-09-2012 01:07 PM - edited 07-03-2021 09:58 PM
Hello,
Can any help me with this questions ?...thanks you.
Cisco Aironet 3602I is stand alone or need a controller ????..
David Chavarria
04-09-2012 01:08 PM
3602's need a controller.
04-09-2012 01:08 PM
3602 is designed to work with the WLC, as is the 3500. Any AP with Clean Air needs to be joined to the WLC to gain the Clean Air functionality.
Steve
04-09-2012 01:11 PM
You also need code 7.2, which means you need a new 2504, 5508 or WISM2. Will not work on older controllers.
04-10-2012 02:57 AM
in General APs can be converted to work with autonomous (standalone) image or an LWAPP/CAPWAP image that needs controller.
for 3600 series APs however there are no support for autonomous image and you can only use it on WLC with version 7.2 or above (7.0 does not work).
7.2 version does not work on all WLC platforms and only works on new platforms like WiSM2 and 2500 WLCs.
I think everyone above mentioned what I wrote but I just tries ot make a good summary.
HTH
Amjad
08-21-2012 10:11 AM
Do you know if there is an autonomous image for this, we were asked to perform a site survey with this model , but we dont want to be carrying WLC to do this,
Thanks
08-21-2012 11:24 AM
No. There is no autonomous image.
08-21-2012 06:05 PM
I'd be interested to hear how others have done site surveys with these units, as it does make it hard without an autonomous image.
08-21-2012 06:09 PM
This was the same issue when the 3500's came out until people found out you can use the 1260 image. What I have seen in the field is using a 2504 and a power pack to power up the 2504. It would be the same if you would have to survey for mesh.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide