Cisco Aironet AIR-SAP2602I-E-K9 - Setting QoS from CLI...

[latitudegroup]

Hey guys,

I'm having a nightmare configuring QoS for Microsoft Lync traffic (DSCP 40) upon my WAP's using the GUI.

Within QoS policies I set:

Policy Name: Lync

IP DSCP: 40   Apply Class of Service: Voice <10ms Latency (6)

Apply Policies to Interface / VLAN's

VLAN 1000

Incoming- 2.4GHZ: Lync 5GHZ: Lync

Outgoing- 2.4GHZ: Lync 5GHZ: Lync

I hit "apply" and the bl**dy GUI changes the IP DSCP from 40 to Class Selector 5.

I've played around in the CLI and can't for the life of me see how to configure the above. If someone could tell me the commands for configuring the above in the CLI I'll be forever in your debt... beer tokens in the post!

Thank you very much for anyone that takes the time to respond to the this post.

[hopkinsjames · Accepted solution]

I think this is correct as DSCP 40 equates to class selector 5, please attachment and info here - http://en.wikipedia.org/wiki/Differentiated_services

[hopkinsjames · Accepted solution]

Also see this for DSCP values - http://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus1000/sw/4_0/qos/configuration/guide/nexus1000v_qos/qos_6dscp_val.pdf

[latitudegroup]

That's fantastic - Thank you James. I thought it was just the GUI being glitchy... again!!!