cisco-AP

[Anjana A]

Hello Team,

tried registering the access point with the wlc and found that this a Mobility express access point.

Is it possible to convert this access point to the capwap controller based access point?

even though after conversion, is it possible to work in flex connect mode?

AP-Details:

cisco AIR-AP2802I-C-K9 ARMv7 Processor rev 1 (v7l) with 1030580/721048K bytes of memory.
Processor board ID FGL2205A4DZ
AP Running Image : 8.2.151.0
Primary Boot Image : 8.2.151.0
Backup Boot Image : 8.5.120.0
2 Gigabit Ethernet interfaces
2 802.11 Radios
Radio Driver version : 9.0.5.5-W8964
Radio FW version : 9.1.8.1
NSS FW version :

Regards,

Anjana

[Sandeep Choudhary · Accepted solution]

Hi,

Yes you can convert from Mobility expres sto Lightweight AP.

Here is the procedure:

https://wifiworkshop.com/2017/09/07/convert-cisco-mobility-express-ap-to-lightweight-ap/

yes ME will work in flexconnect mode.

Regards

Dont forget to rate helpful posts

[Anjana A]

Hello Sandeep,

When i am logge din the cli of the AP, 

it is in mode

> enable

#

so i will be able to perform the above mentioned conversion steps.

Regards,

Anjana

[Sandeep Choudhary]

Glad to hear that it worked.

Regards

Dont forget to rate helpful posts