Cisco AP9115 interface BVI

[heyjunsun]

hello! 

I have a question during the setup.

The products that our company used before are 1600 and 1700 models

In that model, the command example

"bridge irb ( BVI eanble ) " 

" interface Dot11Radion0 " 

" ssid test " 

" station-role root" 

"interface BVI"

"interface GigabitEthernet1"

"bridge-group 1"

When these commands are used, they are not active.

If not, I wonder what other commands have been replaced by.

In the meantime, I set up interface Dot11 with ssid creation and ip address in BVI, but it is difficult because most of the commands are not used in 9115AP.

I need your help 

[JPavonM · Accepted solution]

Catalyst 9100 series cannot be configured in autonomous mode, and thee only option is to convert them into eWC mode (the evolution of previous Mobility Express) and configure it.

https://www.cisco.com/c/en/us/support/docs/wireless/embedded-wireless-controller-on-catalyst-access-points/215303-embedded-wireless-controller-conversion.html

https://www.youtube.com/watch?v=c81VQCeqGNY

https://www.youtube.com/watch?v=oS68E25wc4A

[heyjunsun]

hello JPavonM 

The version I'm currently using is "C9800-AP-universalk9.16.12.04a 

Can I use version 17.09.04 as shown in the picture?

[marce1000]

        - FYI : https://mrncciew.com/2022/07/11/cisco-9100-ap-as-wgb/

 M.

[heyjunsun]

hello marce1000 

I'm confused about what I understand.

Is the WGB from the homepage you mentioned the same as the EWC setting? And on the Cisco homepage, there are three types: "Embedded Wireless Controller", "IOS XE Software AP Service Pack", and "Lightweight AP Software", so which version should I choose over 17?

[Rich R]

No workgroup bridge is when you use 2 APs to create a bridge between 2 LAN segments.

If you are looking for a modern replacement for autonomous APs (which it sounds like you are) then you need to use EWC as @JPavonM  advised.

When selecting a version refer to the latest TAC Recommended link below.  Currently that is:
Cisco recommends 17.9.4 + SMU_CSCwh87343 + APSP (as needed) OR 17.9.4a + APSP(as needed) for all deployments.
But note that SMUs and APSPs are not available for EWC - only for 9800 hardware appliances and 9800-CL.
So currently 17.9.4a is the TAC recommended version to use.