Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hello
I am updating to 9115ap and am using version 16.12.I know that you can't upgrade 16.12 -> 17.09 at once through Cisco's homepage.So I'm trying to upgrade to 17.03.08a first and then upgrade to 17.09.04.I unzipped the 17.03.08a zip file and cop...
I would like to operate 2 products of cisco ap 9115.
You set the virtual controller IP for the two APs to XXX.XXX.XXX.232.
IP was set to 233 and 234 respectively as an Access Point.
If you boot after setting it up like this, one AP will ...
hello
I'm trying to access the AP after setting up, but I can't. Is it possible to do log analysis?
ap->radius server Ping communication is possible.
ID/PW is also correct. When I try to connect to ssid on my device, I can't connect and the logs a...
Hello9115APIOS Version 17.9.4.27 (Recommended Version)I have a 2 questiAs
far as I know, the original EWC-AP configuration is changed to EWC-mode after 3 minutes after booting to local mode, so it asks automatic configuration questions.on about.
Is ...
Hi, I am upgrading my Cisco 9115AXI AP from 16.02.04.a to the recommended version.
The upgrade failed at first, so I switched to u-boot mode and successfully booted with Bundle IOS.
What I'm curious about is that if you want to install the recommende...
Hello, for example, 17.09.04.zip cannot contain images, but when you unzip it, you get the C9800-AP-iosxe-wlc.bin file, so you said you contained this. However, when I searched the Internet, I saw that it was better to contain the full version. Am I ...
Hello, are you saying that I need to receive the image in a different MODE than EWC-mode?
Do I need to change to a mode other than EWC mode before proceeding? I still don't understand even after referring to the documentatio
I ran two at the same time.IP is set to 172.19.96.232 and access point IP is statically given by me 233 and 234 respectively. 1 AP starts with stby -.Is there any setting I need to do before running two APs?
