Re: Cisco IOS and LEAP

c.tenley · ‎08-04-2003

I upgrade a test AP to the new code of IOS for the Aironet 1200s. Before the upgrade we were using LEAP for authentication and it worked fine. With the upgrade, I can not get LEAP to work. We are using Cisco ACS 3.1 for our Radius servers. I believ all my configurations under security are correct, but not 100% positive. Are there different configurations for LEAP between VxWorks and IOS?

derwin · ‎08-04-2003

IOS sends a different nas-port type than VxWorks

This is reported by bug id CSCeb36095

IOS based APs will pass Radius attribute 61 (NAS-Port-Type) with value 5

(virtual), while VxWorks based APs use value 19 (Wireless IEEE802.11)

Users may need to re-configure Radius server setting if this attribute is used

to grant access to the user, when changing AP from VxWorks to IOS.

c.tenley · ‎08-05-2003

Where do I find these settings to compare/change? On the AP itself or the RADIUS server?

Thanks

derwin · ‎08-05-2003

On the radius server

c.tenley · ‎08-05-2003

I hate to sound like an idiot, but where on the Radius servers do I find these settings? We are using both ACS v2.6 and v3.1, and I could not find these settings on either of them.

Thanks