Cisco module controller & 1131 access-point

[mel.farhat]

I'm using a blade as a controller in a cisco router. trouble is it does not see

the 1131 access-points. does see 1020 access points. Any thoughts

[sethgarnar]

If you are using OP 43 to tell the access points where to find the controllers you will need a new entry for the 1130 series of access points.

[mel.farhat]

do you know that entry, we are usung a dhcp server at our head end.

[Rob Huffman]

Hi Mel,

One quick question are you running in Layer 3? The 1131 is not supported in Layer 2.

Rob

[mel.farhat]

yes current mode is layer 3