Wireless

I try to configure 2 ssid's for 1131 autonomous AP. One SSID with open authentication and WEP encryption and the other SSID using WPA. The "WEP-SSID" is in guest-mode. So i can see the "WEP-SSID" in the list of available W-Lans on a notebook but WPA ...

Hello allwe have an WiFi architecture based on two Radius servers (ACS 3.2)We make a Mac adress authentication with WEP on these Radius servers. Ours Wirelless cards are Proxim Orinoco. When we used the user and the passord identified by the mac adre...

I am having some difficulties setting up public wifi for a customer. They currently are using AP1121G access points to provide wifi for corporate users. They would like to add a public SSID to allow visitors to access the internet only (no access to ...

Hi, I bought a used AIR-AP1232AG-A-K9 Cisco Aironet 1200 AP W/ A & G Radios and when it arrived I noticed the stickers on the back said:AIR-AP1231G-A-K9AIR-AP1210AIR-RM20A-A-K9AIR-MP20B-A-K9Is this an AIR-AP1232AG-A-K9? If not, what is it and what's ...

when the laptops default page is set to an https site as a default page. It will not go to the cisco authentication page.any ideas?

Hi,we try to setup a Backup Controller over a WAN Link. I know that the 100mesc is one of the limitations.But what happens to the Routing and DHCP for the client if the Controller is been far away ?Did i have to change something in the Routing Config...

I'm running into an issue where my client connects to a specific wlan using EAP-FAST as the EAP method and am using automatic PAC provisioning, initially everyting is working fine but the connection strength goes from excellent, to poor, then to netw...

Has anyone successfully ssh'd into a 2700 location appliance? I get prompted for a password and enter the root user password I set up during the initial installation without any success.Thank you for any feedback.

Has anyone ran into an issue accesing the service tab to display the service summary page? I ran into this issue while configuring the wap through the browser when suddenly the service tab will not display the services summary page. System Software V...

Hello everybody,I have to ask some easy questions about Wireless WLC implementations.I want to deply a WIFI network with 3 WLANS/VLANs + 1 wired-only VLAN for management purpouse. The access-point and the WLC should be connected to a non cisco layer ...

Hello, we have just deployed an SSID of hVoIP and applied CAC and QoS. It works well. We have a "data" SSID of DATA.Is there a way to only allow the Cisco wireless phones to authnticate to this SSID and block, say laptops or other WiFi phones, from a...

Hello,is it possible to replace the standard lwapp ssc against one of our company CA-certificates to allow the wlc to check the correctness of the aps certificate ? (button under security/aaa/ap policies -> Authorize AP agains aaa on the wlc) Is ther...

I have a fairly large wireless rollout of access points at my hospital's main campus and then I have 41 remote sites that have approximately 3 to 10 access points at each location.My problem is this, I just converted one site from 9 autonomous access...

I have been using RLDP and setting up Rogue sniffers on a trunk port for some time now and it has been working fine. It can detect the rogues on the wired network however when it does detect those rogues it shows the mac address of the wireless radio...