Cisco Prime 1.3

[skelley5000]

I did an opps and deployed the latest IOS image to all of our switches, I have looked and looked for a way to stop the deployment. Right now I have stopped the the service but I need to find out a way to stop the deployment when I turn Prime back on???

Thanks

[Sandeep Choudhary]

Hi,

Prime Infra# ncs stop - Stops the Cisco Prime Infrastructure server

Prime Infra# ncs status - Shows the Cisco Prime Infrastructure server status

Prime Infra# ncs start - Starts the Cisco Prime Infrastructure server

Regards

Dont forget to rate helpful posts

[skelley5000]

so this will stop the image deployment..just want to make sure

[Sandeep Choudhary]

NO this is the process to stop Prime infra after installation.

Regards

[skelley5000]

well my question was how to stop an image deployment if you have chosen multiple switches instead just the one you want

[Scott Fella]

If you started a job to push an image, then you need to go to the job and delete that job if its not too late.

Thanks,

Scott

*****Help out other by using the rating system and marking answered questions as "Answered"*****

[Naveen Kumar]

If you attempt to uninstall Prime Fulfillment as root, but root is not the Prime Fulfillment owner, if you attempt to use the ./prime.sh stop command to halt all Prime Fulfillment processes, the processes will remain running. If you did not install as root, use the ./prime.sh stop command before following the next steps, but be sure to execute ./prime.sh stop only as the Prime Fulfillment owner.