Cisco Prime Infrastructure 2.0 associate tasks to controller

[Beheer tno-netwerk]

Hi ,

how can i schedule 2 or more tasks in CPI for one Wireless Lan Controller.

For example to download  *.aes software , reboot and 2 hours later download *.ER.aes software and reboot ?

Thanks

[Sandeep Choudhary]

Hi,

Check : this is for WCS but in PI it almost similer:

Fot software related schedule task: Configure  >  Scheduled Configuration Tasks  >  Download Software Tasks

http://www.cisco.com/c/en/us/td/docs/wireless/wcs/7-0MR1/configuration/guide/WCS70MR1/ctrlcfg.html#wp1098833

Regards

Dont forget to rate helpful posts

[Beheer tno-netwerk]

Hi ,

i want to schedule 2 tasks after each other ( 2 hours in between)  for the same Controller.

CPI  said "You cannot associate a Controller with more than one task" , is there another way

to do this  job

We want to upgrdae our WLC software version and Emergency Image Version in one night.

[Sandeep Choudhary]

NO You can only schedule a single task for one controller.

Fisrt you can upgarde the software of the WLC and then you can only do the emrgency upgrade.

there is no other way. You must take a downtime for this and you have to do it manually. Its always better to do it manually if you have not so many WLCs.

Regards

Dont forget to rate helpful posts

[Beheer tno-netwerk]

ok Thanks for your time

[Sandeep Choudhary]

If you are satisfied with above answer then can you please mark this question as answered, it may help others. Regards Don't forget to rate helpful posts

[Naveen Kumar]

You can schedule only single task :

http://www.cisco.com/c/en/us/td/docs/wireless/prime_infrastructure/1-2/configuration/guide/pi_12_cg/ctrlcfg.html#wp1081605