02-19-2021 12:06 AM - edited 07-05-2021 01:15 PM
Hello,
I have an issue with my Cisco AP WAP4410N Device. The Wrieless Light does not come on and the Hard Reset of the Device does not work and I dont have the IP Address range of the device
Any Solution or help in this regard would be highly appreciated.
Regards
Kumar
02-19-2021 12:15 AM
- How are you powering the device and or does it get sufficient power ?
M.
02-19-2021 12:57 AM
I am Powering on the Device thrru an PoE Switch
02-19-2021 12:59 AM
Any Utility to find the IP Address of the Device which is not in the same network range
02-19-2021 05:35 AM
sh cdp neigh detail
02-19-2021 04:10 AM
- Issue show power inline on the switch , check power being provided to the AP , compare this with requirements which can be found in the datasheet.
M.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide