Cisco WLC CLI AP AP-GROUP ASSIGN

[Aydin Ehtibarov]

Dear colleagues, 

i am trying to change AP group name for 180 access-points. I would like to do this over CLI . But the issue is every time i past the config line WLC request confirmation as below:

(Cisco Controller) >config ap group-name Apartment-Rental AP-APP-203_1

Changing the AP's group name will cause the AP to reboot.
Are you sure you want to continue? (y/n)

as the result i cannot past all 180 lines at ones to cli and finish the task

is there any "noconfirm" option to use with this command ?

thank you in advance! 

[Flavio Miranda]

Hi

   There´s no "no confirm" but you can add Yes and go ahead. Are you using a spreadsheet?  

[jagan.chowdam]

In the past, I used Excel and added "y" in a new row for all commands and it worked.

CJ

[Haydn Andrews]

Been caught out by this before.

I used subline text to insert a line under every "config ap ..." and added "y" as the value on that line.

Then it works when you paste it into the CLI.

[Rich R]

Just make sure you're on latest AireOS.  There was a regression bug we found in earlier 8.8 that when you tried to paste in a lot of commands with prompts like that the buffer choked so you could only do a few lines at a time.

https://bst.cloudapps.cisco.com/bugsearch/bug/CSCvn47094