cisco wlc2504 vs ipv6 client

[pawarut]

cisco wlc 2504

Software Version     8.2.161.0

not send attribute "framed-ipv6-address" to my radius accounting servers.

but send only attribute "framed-ipv6-prefix".

*** I used command "config wlan radius_server acct framed-ipv6 both {wlan number}".

[Sandeep Choudhary]

It must work with the above command:

config wlan radius_server acct framed-ipv6 both

"https://indico.cern.ch/event/592622/contributions/2576502/attachments/1475412/2286370/20170613_ipv6_security_hepsysman.pdf"

May be you can run this command , save  WLC config and reboot it. Later try again...

Regards

Dont forget to arte helpful posts

[pawarut]

I use freeradius2 on ipv4.

but I see only attribute "framed-ipv6-prefix".