Clearing a MAC address ACL using CLI

[airlink]

We're getting an error when we try to use the GUI to add and remove MAC addresses from a our ACL for filtering purposes. Cisco's doc says that we need to delete or clear the existing ACL using the CLI in order for us to get rid of the error message showing up in the GUI.

Any help would be appreciated.

[Rob Huffman]

Hi Bill,

This is a very helpful doc;

Access Point ACL Filter Configuration Example

http://www.cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a008058ed26.shtml#macbasedacls

Hope this helps!

Rob