04-16-2021 08:42 AM - edited 07-05-2021 01:09 PM
Hello Experts if somebody can help me with erasing the WISM configuration from WS-C6509-E, the information is mentioned below from the 6500 chassis
Mod Ports Card Type Model
--- ----- -------------------------------------- ------------------ -----------
1 3 ASA Service Module WS-SVC-ASA-SM1
2 1 Application Control Engine Module ACE30-MOD-K9
3 4 WiSM 2 WLAN Service Module WS-SVC-WISM2-K9 <<<<<< wism module
5 5 Supervisor Engine 2T 10GE w/ CTS (Acti VS-SUP2T-10G
6 5 Supervisor Engine 2T 10GE w/ CTS (Hot) VS-SUP2T-10G
04-16-2021 08:47 AM
Have you looked at any guides for factory reset? You have a console port and can reboot the module and then break out and there are options to clear configuration.
04-16-2021 08:56 AM
Hi Scott, the 6500 FAQ talks about resetting the WISM from its CLI.
from the 6500 switch perspective is there command guide to clear the WISM configuration ?
04-16-2021 08:58 AM
I think you need to use the console or get into the WiSM cli.
04-16-2021 08:48 AM
M.
04-16-2021 08:55 AM
hi there , this i have already seen , i am looking to have if there is any command to clear the configuration for WISM from the switch ?
04-16-2021 05:38 PM
04-19-2021 07:57 AM - edited 04-19-2021 07:58 AM
- Physically remove the WISM from the 6500 (remember to replace with a blanking plate for proper cooling air flow) after power down the slot (conf t, no power enable module 3)
- conf t and "no x x x x" the remaining WISM specific config on the 6500 just like you would for any other IOS config.
- Follow instructions others have given if you want to erase the WISM configs (barely worth the effort unless you have private/confidential info in the config) via console, either before you remove it or bring it back to your own site.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide