03-15-2016 07:12 AM - edited 07-05-2021 04:47 AM
Is there any command to find the Native Vlan (configured under FlexConnect tab) of ALL access points in WLC?
I have a Flex7500 and running code 8.0.120.0
Thanks,
Mehdi
03-15-2016 11:36 AM
Since this configuration is AP specific you need to check this in each AP. Below CLI should help
(2504) >grep include Native "show ap config general <AP-NAME>"
Press any key to continue..y
AP Native Vlan ID: .............................. 1
Native Vlan Inheritance: ........................ Group
Native ID :..................................... 1
HTH
Rasika
*** Pls rate all useful responses ***
03-15-2016 12:43 PM
Thanks for your answer!
When you have 4000 APs on controller, it's gonna be difficult to check one by one.
Someone from TAC recommended me to use WLC Analyzer which give a better view than CLI commands.
Thanks anyways...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: