Re: CLI Commands needed for a SW Catalyst2960 port work for AP Aironet

pdenableetoavit19698 · ‎03-03-2023

Hi there

I want to make an empty port on a cisco catalyst 2960+, available/ok for connecting an extra AP Aironet 1830 under ME.

Which command should I use to make the port TRUNK and any other config needed for that port?

Thank you

marce1000 · ‎03-03-2023

- Review this document https://www.cisco.com/c/en/us/support/docs/wireless-mobility/wireless-vlan/68100-wlan-controllers-vlans.html and or as a example : https://www.cisco.com/c/en/us/support/docs/wireless-mobility/wireless-vlan/68100-wlan-controllers-vlans.html#anc10

M.

-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

CLI Commands needed for a SW Catalyst2960 port work for AP Aironet1830