Wireless

Hello!I had 16 AP's, but jut noticed that 4 of them are not joining on the Wireless Controller. They are connected to a different switch, but they are all getting the IP from the management VLAN. I can ping them from my computer, switch and even the ...

Hi, I just received a technical request and need some help.Does anybody know whether Cisco Air Cap2702i-E-K9 do support radiated power sink function?Which Software Version is needed?Any experience? Feedback is very appreciated.Best regards ex Belgium...

What is the difference between an indoor and outdoor antenna. I can see from the specs that outdoor antennas can operate in lower temperatures, but is that the only difference. Are outdoor antennas better sealed against weather? What I'm wondering...

I need to update the firmware of the Cisco wireless product AIR-CAP3702P-E-K9. I would like to make it as a stand alone wireless device.

Just a quick question. When configuring ports facing the WLC, the port facing the WLC management should be switch access vlan management with trunks for the SSIDs, correct?Ports facing APs should be native management vlan and allowed ssid vlans, corr...

Hello,We are quoting equipment for a new site.The 2602 AP's we normally get have been replaced the the 2702.The 2702 supports 802.11ac, but only when a POE switchport is providing 20w power.Our 2960 switches (WS-C2960+48PST-L) running at 15.4w per sw...

Which port do I plug into. Consol. Aux or Poe 

Hi, We are going to setup a Wireless Network with the following products, we would request you to provide us an accurate answer about their workability Controller : AIR-CT5508-50-K9Access Point : AIR-CAP2602I-N-K9            x10NosAccess Point : AIR-...

I successfully added an MSE to PI2.1.  It is reachable and communicating just fine.  I added a map to PI and for a change it turned out very well.  The problem is when I take a look at a client there is no information regarding the client's location ...

Hey everybody, I need to clean up old computers who aren't present in the network anymore in Meraki softwareWhat's the best solution do this in the Meraki software ?I figuared out that I can do this manually but is there an automatic way?ThanksJonas

Hello Guys!First of all sorry if i requested this information out of the right session!Im beggin on it!I use a chromecast in my room and i had been using it very well until friday.Since Friday i have been problems configuring it!When i try to log my ...

I have a organisation (using meraki WLC) and they wants to access our NAC guest server via webauth. Internally we have Cisco WLC with Cisco NAC guest servers.What are the best way so achieve the objective above?Would you recommend having the Merika W...