03-19-2012 07:28 AM - edited 07-03-2021 09:49 PM
I have a client with two identically configured WLC's running 7.0.230.0 with approximately 370 AP's. We are currently testing before going into production and found that once the 2nd WLC comes online (same mobility/RF group), the clients are no longer able to connect / obtain an IP address. We removed all security and still had the same issue when the 2nd controller came online. This sounds like a bug and I'm thinking about upgrading to 7.2x, however, that requires upgrading the MSE/NCM. Although I don't mind doing this upgrade, I was just wondering if anyone else has ran into this issue.
I did run both configuration files through the WLC Config Analyzer and nothing seems to jump out other than some typical RF issues.
Thanks,
Bob
03-20-2012 03:23 AM
Bob
Have you checked to make sure you don't have any IP address duplications between any of the interfaces of the controllers?
Regards
Simon
03-20-2012 10:19 AM
Simon,
No IP Conflicts. Ironically, when we broke the Mobility Group, everything is working fine and clients are able to obtain their IP addresses from the DHCP servers.
Re,
Bob
03-20-2012 10:21 AM
Is the WLAN anchored?
Sent from Cisco Technical Support iPad App
03-20-2012 10:35 AM
No they WLAN's are not anchored.
03-20-2012 11:59 AM
Can you post the configs? Feel free to scrub them so bling as we have the mobility interface and WLAN configs.
Steve
Sent from Cisco Technical Support iPad App
03-20-2012 03:18 PM
It appears the MFP on the AP's was off on one controller.
Thanks for trying to help.
Re,
Bob
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide