Couldn't SSH or HTTP to the controller by using 9800
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-22-2022 01:51 PM
after creating a new WLAN, I get the connection to that SSID, get the right IP address, and can go to the internet, and intranet, but couldn't SSH or HTTPS to the WLC. it is pretty weird, any one has any idea about this?
thanks in advance.
- Labels:
-
Catalyst Wireless Controllers
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-23-2022 05:34 AM
- If you need management access (SSH/HTTP) through wireless then use or configure : Configuration > Wireless: Wireless Global > Management Via Wireless: Enable
- Appendix and or always useful : Review the 9800 configuration with the CLI command : show tech wireless , have the output analyzed by https://cway.cisco.com/
M.
-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-11-2022 01:04 PM
Me thinks the WLAE is having issues. I upload my 9800-40 show tech wireless output and it just burps back to the upload screen after RUN.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-11-2022 02:13 PM
I downloaded the desktop version and wcae ran without issue.
maybe an issue of the cloud talking back..
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-26-2023 09:05 AM
thank you guys.
