Hey Community! I'm excited to share something we've been working on that I think will really resonate with many of you managing wireless networks today. We just released the Cisco State of Wireless Report 2026, based on insights from over 6,000 wirel...
Forum Posts
Hello friends, I have a virtual WLC 9800 running version 17.6.5. A client is unable to connect from a specific PC, but can connect successfully from other devices. I have verified the credentials, and they are correct. The specific PC can connect nor...
I'm not sure what the issue is, but the splash page doesn't appear. Some devices connect initially, but they no longer have an internet connection. I would want to do a test. I have a technician in the area who can connect through a laptop for the fi...
I have a strange question, I have installed 5 Meraki WIFI MR36 antennas in the company, I wanted to know if it was possibleblock the connection of a specific device to a specific access point, example my smartphone can connect to all the other 4 ante...
Splash page not showing automatically for Guest users , pleasae support.
Hello All,I am relatively new to Meraki access points and I need to set up a guest ssid that points to a Forescout captive portal where users will enter their email address and other information to get a token so they can log into the guest network.A...
Hi all!We have a networks mixed with Cisco Classic Switches and Meraki APs. In one of them there are issues with one of the SSIDs. One C2960 switch connected to MR44 APs and one C9200 connected to MR36 APs(both with version 30.6). It is not possible ...
We have several P2P bridges connecting buildings between 50-700 feet apart (usually line of sight). We're currently using a mix of EOL Ruckus bridges and some Ubiquiti bridges. I found that I can do meshing with 9124's via our 9800 controller. I real...
I'm trying to join a 2800 series to a 9800 on a 5500 controller. I changed the controller IP with capwap ap primary-base command in AP. But APs is not moved from 5500 to 9800. Do you need additional work??
Resolved! Cisco 9501 AXI WLC issues
Good morning!I have a cisco 9501 that i am setting up as the WLC. I used the air provision ssid for setup. It broadcast the new ssid but when i connect to the new ssid i cannot access the portal page for the wlc. i also cannot access the portal from ...
I'm new on this job and I have been trying to correct a lot of wireless issues. I've added more wired APs and upgraded a lot of APs off the old 5500 controller. I'm not going to say I'm a wireless guru because I'm not, but I am able to configure APs ...
Hello all,Please help with the basics check list to be configured on the wlc and ise for the guest captive portal.Recently we have implemented the guest captive portal, most of the users not able to connect. Regards,Anjana
Hi, has anyone seen this behaviour before?If I look in the RF Spectrum page, it lists only channels 36-64 with any data. However, if I go to the RF-profile I can see the access points are using a larger spread? Any ideas?
Hi there, I encountered a strange problem today with OWE in transition mode.Suddenly a handfull of users could not see the OPEN SSID at all. But when they moved to another section of the office they got the OPEN SSID and were able to connect. After t...
Resolved! WiFi unstable
Hi everyone,we have an odd issue. We are testing two CW9164I, where we have clients getting 3x "Destination Host Unreachable" than pings are fine, and after a while it comes up again. So Google Meet etc is not working properly, because they have thes...
Dear All, Any meraki AP ethernet interface support 802.3bz ? Thanks Keith
