cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
256
Views
0
Helpful
1
Replies

Create a radio channel alert

DAVID
Level 3
Level 3

Where can I go to create an alert so that Prime will notify me whenever the utilization on either radio interface on a 3700i access points reaches a certain percentage utilization?

1 Reply 1

Scott Fella
Hall of Fame
Hall of Fame

On the controller, you can set the threshold for AP utilization. The default for this trap is 80.  This setting can be found under Wireless > 802.11<a/b>> RRM > General

i typically just run reports on PI to look at utilization historical data.

-Scott

*** Please rate helpful posts ***

-Scott
*** Please rate helpful posts ***
Review Cisco Networking for a $25 gift card