Create ACL templates for 9800 WLC in DNAC/Cat Center

[Wes Schochet]

Hi All-

In the "old world", I would go into Prime Infrastructure Configuration -> Features and Technologies -> Controller -> Security -> Access Control Lists  to create  and ACL for my 5500 WLCs. I would then go to Configuration -> Features and Technologies -> My templates to deploy these to the WLCs.

I now need to do similar ACL creation and deployment operations for my 9800s in Catalyst Center.  I am looking for documentation or a good tutorial that could help me create these new processes.  CatCenter 2.3.7.5 if it matters...

Thanks again for your continued support,

Wes

[Haydn Andrews]

With Catalyst Centre (DNAC) the WLC needs to be managed via intent to be able to do this, it cant be just in assurance mode.

Design>Network Settings>Wireless>Pre-Auth Access Control Lists

Is where you configure WebAuth ACLs

any other ACLs need to be done via CLI template