Create Native VLAN Flex Profile

[CSCO12971535]

When creating the native VLAN (3035) as shown in the image.

It reverts to the default VLAN (1) upon saving.

Could this be a bug? 

WLC 9800 Version 17.18.3

[Mark Elsen]

  - @CSCO12971535                   Check the logs on the controller when trying and or fall back to the CLI
                                                    for these configuring operations because you may get more informative
                                                    fault messages immediately

  M.

[balaji.bandi]

Did you added VLAN before you using it ?

Open your Flex Profile properties pane (Configuration > Tags & Profiles > Flex).

Click on the VLAN tab (located next to the General tab).

Click the +Add button inside the VLAN grid.

Fill in the parameters:

VLAN Name: Native-3035 (Or any descriptive name)

VLAN ID: 3035

Click Save 

Then Add what you desired to add.

Make sure switch side same configuration replicated. native VLAN in trunk

[aleabrahao]

@balaji.bandi You don't need to create a VLAN; I have VLAN 120 defined in my FlexProfile, and I don't have that VLAN created on the WLC. This looks like a bug to me.
@CSCO12971535 Try configuring it using a different browser.

[balaji.bandi]

I am not sure It looks like a different outcome or Code , but with 17.9. X, I created a VLAN, and it worked for me. (There is no harm in trying that option) 

[Rich R]

It works fine for me on 17.18.3 with Firefox 151.0.2 without having to define the VLAN.