Hello,
I will need to set up a new AP (CW9164I-E) for a test setup.
It will receive IP address via DHCP, however I can´t configure DHCP Option 43/DNS records for different reasons.
I hope the AP receives IP address via DHCP, and I will try to access the AP via IP address via SSH.
Then apply manually this command on the AP via SSH:
config ap capwap primary-base <IP_Address_of_the_Target_WLC>
For that I would like to validate the following points:
1- Is the SSH enabled by default?
2- What is the default Username/Password
Thank you