04-11-2019 02:30 PM - edited 07-05-2021 10:14 AM
I have a cisco aironet AIR-LAP1242AG-E-K9 acces point that runs v12.4. if its any use this is the firmware in flash:
BOOT path-list: flash:/c1240-k9w7-mx.124-10b.JA3/c1240-k9w7-mx.124-10b.JA3
I'm trying to get debug to show wireless clients connecting and disconnecting in the console in real time. I did search this forum but debug client <mac-address> doesn't work. (% Invalid input detected at 'client'). I need this debug because the wireless connection from a client laptop is dropping after a minute or so. I don't know whether this is a problem with the laptop of the access point. I also read something about a 'timeout' setting. Where would i find that? thanks for any help.
04-11-2019 02:52 PM
Hi Tony,
Go to enable mode and run the same command. Autonomous AP Debug Commands is for your ref.
04-12-2019 01:14 AM
thankyou for that, the command that worked was:
debug dot11 dot11radio0 trace print clients
I'm still puzzled however by 'timeout'. and whether my AP is configured in some way to drop client connections. I've looked under # and config t and cannot see a timeout setting. I should also clarify I'm configuring the AP through a telnet session using putty on a windows pc. Thanks for any further ideas.
04-12-2019 01:59 AM
04-12-2019 05:58 AM
04-12-2019 06:21 AM
04-12-2019 09:22 AM
04-14-2019 11:58 PM
This provides zero (0, NULL) security!
Mac address can be copied within seconds (just sniff the packets of a single active client) and the WEP key can be cracked within 2 minutes on an iPhone6, or way faster on a modern computer.
That's all it needs for the attacker to gain full access to your wireless, 2 minutes.
04-12-2019 05:32 AM
04-12-2019 06:03 AM
Check this thread Session Timeout Autonomous AP
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide