I've got an SSID that I would like to send out to a public subnet (wifi for guests in the building) but because it's public i don't want to waste a lot of addresses. So i'm considering a DMZ-type area for the clients to get a RFC1918 address with a single address on the outside.
Something like this:
Clients -> WLC4402 -> 10.x.x.xpool -> ??? -> Public subnet
I know the WLC can dish out my 10.x.x.x subnet to the clients. But my question is the ??? between that and a single IP address and the Public subnet.
The WLC can't handle that part can it?
Obviously i could just use a simple linksys router or something to handle that and the ip address pool, but i was hoping there was something in the WLC that can handle it all for me.
Ideas? Suggestions?
Thanks in Advance!