04-11-2011 12:43 AM - edited 07-03-2021 08:03 PM
Hi
I have a WLC5508 and are using the management interface as a AP mgmt interface. I want the WLC to be the dhcp relay for the AP .
The AP is on the same Layer2 vlan as the WLC mgmt interface
The DHCP server is on another vlan, and i am pointing to the DHCP server adress in the interface setup on the Management. Wil the ap get an ip adress based on this setup ?
Regards
Even
04-11-2011 12:52 AM
yes it is possible..
Just make sure we have the network connectivity between the WLC and the DHCP server..
lemme know if this answrered ur question!!
Regards
Surendra
04-11-2011 01:05 AM
Ok so this means that the WLC wil response to the DHCP boot request from the AP ?
04-11-2011 01:34 AM
Hi,
The WLC will come into picture only when the AP grabbed an IP.. the switchport on which the AP is connected, should be mapped to the respective VLAN and this will do the job for you so that the AP wil get an IP, after this the AP tries to find the WLC..
Lemme know if this answered ur question!!
Regards
Surendra
04-11-2011 01:46 AM
Ok thank´s. Then I understand
Regards
Even
04-11-2011 01:48 AM
Thats nice to hear!! and thanks for using CSC..
Please dont forget to rate the post!!
Regards
Surendra
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide