06-10-2010 01:23 PM - edited 07-03-2021 06:52 PM
Hi,
On autonomous AP's one can disable the bright status LED using the "led ....." command. But how can I disable the LED on a LAP-1131AG? The AP hangs in a bedroom so the light is quite annoying.
Thanks!
06-10-2010 01:25 PM
OOPS.... found it already..
config ap led-state disable all
05-08-2013 01:21 PM
Anyone know if this can be done through the web GUI, or just on the command-line?
05-08-2013 02:57 PM
Anyone know if this can be done through the web GUI
Depends on the firmware of the WLC.
7.0.X doesn't support this on GUI but 7.4.100.X does.
In 7.0.X, you can enable/disable LED globally but 7.4.100.X have an option to do so individually.
NOTE: Not sure which firmware starts the support but all my WiSM-2 are running 7.4.100.X.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide