Does Cisco 1850 support mesh?

[lequangthinh123]

I see the link web: 

https://www.cisco.com/c/en/us/products/collateral/wireless/aironet-1850-series-access-points/datasheet-c78-734256.html

Say that : Ap 1850 series support mesh in the future, but now is not support

Is this information correct and up to date?

Thanks and best regards

[Sandeep Choudhary]

As per my knowledge its not supported yet but its planned for future:

https://www.cisco.com/c/en/us/products/collateral/wireless/aironet-1850-series-access-points/datasheet-c78-734256.html

Regards

Dont forget to rate helpful posts

[Rich R]

Actually the document which should have the latest info is https://www.cisco.com/c/en/us/td/docs/wireless/access_point/feature-matrix/ap-feature-matrix.html

That suggests 1850 does support mesh on AireOS and IOS-XE.

Assume latest release in each case otherwise you'll need to trawl through release notes to work out which release introduced the support.

[Arshad Safrulla]

Just to add on top of what @Rich R & @Sandeep Choudhary  support depends on the WLC model, firmware. 9800 for sure supports that. For certain COS AP's mesh support was added on later AireOS codes, but I cannot find a conclusive list.

But again depending on your requirement you may take a look on to the other options like WGB. WGB support for Wave2 AP's (1850) is there starting AireOS 8.8 and all the IOS-XE codes.