Buy or Renew
Buy or Renew
NEW: Try the Beta AI Summary feature on posts in the Routing and SD-WAN forum. Click to go to the forum.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
1119
Views
0
Helpful
1
Replies

Duplicate IP address detected from loopback

mheidemann
Community Member

‎12-02-2005 01:09 PM - edited ‎07-04-2021 11:23 AM

Im receiving a duplicate ip address fault from WLSE loopback address of 127.0.0.1. Is this possible? The fault description says "Duplicate ip address detected. Please check the Duplicate IP folder in the Device tree." I do not see any Duplicate ip folder in the device tree. I have looked under devices > group management as well as reports > device center.

Any help is greatly appreciated.

Labels:
0 Helpful
1 Reply 1

sethgarnar
Level 3
Level 3

‎12-08-2005 05:41 AM

I have seen the same error messages on my WLSE. I just ignore them, its never caused an issue.

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking for a $25 gift card