Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

I work for a reseller and am trying to put a demo box together that will include WCS.I am using WCS 3.0 and VMWare 5.0 on a Windows 2000 Advanced Server.I had worked fine on this server before, but doesn't seem to work on the virtual server on the sa...

RaveDave1 by • Community Member
  • 835 Views
  • 1 replies
  • 0 Helpful votes

Hi,I have some barcode portable DOS terminals in which i have installed LMC352 client cards. So, i have to work with last known good firmware v4.25.30.In those Wlan that have static wep data encryption enabled, after some usage some cards stopped wor...

bartscorp by • Community Member
  • 587 Views
  • 1 replies
  • 0 Helpful votes

Hi Everyone,I have a current problem when a client will roam to a repeater AP and will lose layer3 connectivity. I am currently looking into the 50% overlapping coverage as the possible problem. I am able to access the repeater via telnet and http wh...

psion by • Community Member
  • 586 Views
  • 1 replies
  • 0 Helpful votes

Quick one, what do the three LEDs on the 1232AG access point indicate? I assume its the usual status, activity, etc. but in what order? The documentation does not include this info!Thanks

darrenj by • Level 5
  • 630 Views
  • 1 replies
  • 0 Helpful votes

Anyone out there have an istallation guide for one of these? I have acquired one for home use and need to default it so as I can set security on it. Any help would be appreciated.

someone mentioned to me today this to me today and I can't seem to locate any information on the cisco website regarding it. supposedly its a new access point that function like a thin client? does anyone know what this is called or anything about it...

aletoledo by • Community Member
  • 531 Views
  • 1 replies
  • 0 Helpful votes

I've successfully upgraded one of my Aironet 1100 APs from 12.2(13)JA4 to 12.3(7)JA. However, when I associate a device to the AP I cannot pull an IP address from my DHCP server. The AP is on the same segment as my server DHCP, so there is no routing...

eric.jordan by • Community Member
  • 821 Views
  • 2 replies
  • 0 Helpful votes

We have a bridge up and running that occasionally drops, the timing of the drops is not consistent, so doesn't appear to be a timer per se.Here are the Dot11Radio config'sRoot Bridgeinterface Dot11Radio0 no ip address no ip route-cache ! ssid tsunami...

mothdiver by • Community Member
  • 2777 Views
  • 7 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card