enable ssh for all the ap?

[raymond wang]

Hi

Can I enable the ssh for all the AP which connected to the controller- either from controller or from PI? It take much time to configure the AP one by one...

Thanks

[Rasika Nayanajith]

Hi

go to WLC CLI & apply the below command

(5508-1) >config ap ssh enable all

SSH will be enabled in the Cisco APs joining henceforth

(5508-1) >save config 

Are you sure you want to save? (y/n) y

Configuration Saved!

HTH

Rasika

**** Pls rate all useful responses ***

[raymond wang]

Hi Rasika,

which version are you using? from the 7.0.98 i do not have this "all" configuration..

(Cisco Controller) >config ap ssH enable ?
               
<Cisco AP>     Enter the name of the Cisco AP.

(Cisco Controller) >config ap ssH enable all

Cisco AP name is invalid.

[Rasika Nayanajith · Accepted solution]

I am running 7.6.x & looks like it is a feature added in that version. Even 7.4.x I cannot see that option.

(5508-1) >show sysinfo

Manufacturer's Name............................ Cisco Systems Inc.
Product Name................................... Cisco Controller
Product Version................................ 7.6.100.8

HTH

Rasika

*** Pls rate all useful responses ****

[raymond wang]

thanks Rasika

[kaaftab]

up need to upgrade .

[M. Wisely · Accepted solution]

If you have prime infrastructure, you can create a lightweight AP template that enables SSH and then select all your APs. This should work for all controller code versions.

[StevenH9608]

I am not on this version but any new people finding this thread:

Cisco WLC > Advanced > Wireless > Access Points > Global Configuration > Global Telnet SSH > SSH

[kamal4zmi]

do i need to create usrname ands password for it?