cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2039
Views
0
Helpful
5
Replies

ERROR!!! Command is disabled

arrimage
Beginner
Beginner

Hello everybody,

I have a problem with some access point:  AIR-LAP1252A6-A-K9
                                                      version: 12.4

I don’t have write de command:

AP#debug lwapp console cli

AP # lwapp ap ip address  192.168.1.100 255.255.255.0
it put this : ERROR!!! Command is disabled

 

Please someone have an answer?!!
 

Thinks for your time,

1 Accepted Solution

Accepted Solutions

The AP will need to be converted to an autonomous AP.

See link below, which discusses the process.

https://supportforums.cisco.com/discussion/11222501/it-possible-change-ios-1252-lwap-ap-autonomous-ap

 

 

Hope this helps.

Please rate helpful posts.

Thanks.

*********************************************************

You will need a valid CCO account that has the rights to download the autonomous code for the AP.

If you don't have the rights, you can contact your vendor and they should be able to help you out.

View solution in original post

5 Replies 5

Charles Hill
Rising star
Rising star

Is the ap registered to a Wireless lan controller?  If so, that is the reason for the error.

 

See link below.

https://supportforums.cisco.com/discussion/12056821/command-disabled-when-setting-ip-address-air-lap1252g-k9

 

Hope this helps.

Please rate helpful posts.

Thanks.

Thank you for your answer, but I have problem, the  controller is finished it is dow, What I do in this case because the controller is dead!

There is a way other solution  without controller?


Thinks for your hep.

The AP will need to be converted to an autonomous AP.

See link below, which discusses the process.

https://supportforums.cisco.com/discussion/11222501/it-possible-change-ios-1252-lwap-ap-autonomous-ap

 

 

Hope this helps.

Please rate helpful posts.

Thanks.

*********************************************************

You will need a valid CCO account that has the rights to download the autonomous code for the AP.

If you don't have the rights, you can contact your vendor and they should be able to help you out.

Thank you very much,

 

good idea, all the antennas are connected to the controller!

 

Thank you very much

 

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers