cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
4550
Views
0
Helpful
3
Replies

Error update images for Wireless Controller WLC 2500

Dani Simanjuntak
Beginner
Beginner

I have problem When I want to update images for Wireless Controller WLC 2500,
I choose number 6 when Boot Loader Menu shown.

For your attenttion, thankyou.

 

============================================================
 Boot Loader Menu
============================================================

 1. Run primary image (Image not found) - Active
 2. Run backup image (Image not found)
 3. Change active boot image
 4. Clear configuration
 5. Format FLASH Drive
 6. Manually update images

------------------------------------------------------------
Enter selection: 6
Launching...
Launching images...
init started: BusyBox v1.6.0 (2009-02-03 04:56:32 EST) multi-call binary
Mount failed for selinuxfs on /selinux:  No such file or directory
starting pid 655, tty '': '/etc/init.d/rcS'
Use DHCP for ip configuration (Y/n)? n
Enter switch IP address: 192.168.1.12
Enter switch netmask: 255.255.255.0
Enter switch gateway: 192.168.1.10
Enter TFTP server IP address: 192.168.1.10

You have entered:
     IP Address     : 192.168.1.12
     Netmask        : 255.255.255.0
     Gateway        : 192.168.1.10
     Server Ip Addr : 192.168.1.10

Is this correct(y/N)? y

!!! WARNING updating using .aes or unapproved files will disable this unit !!!

Do you want to update RTOS (y/N)? y

Do you want to update Primary Or Secondary Image (P/s)? P

Enter filename for RTOS update: AIR-CT2500-K9-1-8-0-0-FUS

1 Accepted Solution

Accepted Solutions

but from where I can download the RTOS image?

Cisco TAC can publish the RTOS image. 

should I use RMA service for sofware fail? 

This is normal.  You can RMA the unit.

 

View solution in original post

3 Replies 3

Leo Laohoo
VIP Community Legend VIP Community Legend
VIP Community Legend

Enter filename for RTOS update: AIR-CT2500-K9-1-8-0-0-FUS

That is not a valid RTOS image. 

 

You have two choices:  Contact TAC and ask for an RTOS image or you get your appliance RMA-ed.

thankyou for your answer, but from where I can download the RTOS image?

should I use RMA service for sofware fail? I think this not serius problem.

but from where I can download the RTOS image?

Cisco TAC can publish the RTOS image. 

should I use RMA service for sofware fail? 

This is normal.  You can RMA the unit.

 

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers