Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
424
Views
0
Helpful
1
Replies

failed tacacs+ user authentication

venancio.martinez
Level 1
Level 1

‎03-25-2003 02:41 AM - edited ‎07-04-2021 08:35 AM

I want to autenticate admin users in a AP350 with v12.01T1, with a tacacs+ server (ACS v3.1).

I configured on the AP350 an authentication server, port 49, tacacs, correct key, etc.

I configured the aaa client, users, etc, and I obtain in the ACS "failed attempts" this message: "CS password invalid". I am sure the password I typed was correct.

Does anyone know what could be happening?

TIA

Labels:
0 Helpful
1 Reply 1

rprpalmer
Level 1
Level 1

‎03-25-2003 05:42 AM

I had the same thing. Make sure that if you are doing MAC authentication or any authentication. Make sure you observe case sensitvity. The MAC addresses are sent to the ACS server as all lower case.

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking for a $25 gift card