Wireless

We recently deployed Cisco 1231 APs (cisco AIR-AP1231G-A-K9).The software version is Cisco IOS Software, C1200 Software (C1200-K9W7-M), Version 12.3(4)JAAs soon as these APs are powered on, we immediately lose connectivity to our existing Symbol APs....

Hi,I have installed a Cisco 1310 Aironet Bridge/AP as an Access point for local wireless network connectivity. Every thing is working fine. When I connect Dell Laptop with built-in wireless adapter, it connects successfully. The problem occurs with t...

I'm trying to get RADIUS authentication working using Windows 2003 IAS and an AP1200, client is an AIR-CB21AG with latest drivers (2.1). Can anyone point me to a "how to" guide or advise how to configure each component to get it all working?Thanks in...

Does anyone know what the guidelines are for number of clients talking to one 1231 b/g AP? I know that a lot of it depends on traffic volume per client. However, I am trying to get some idea of a rough guess. I currently have 15 clients on one AP and...

We have 4 1200 AP's, 3 are master, 1 is repeater. The repeater goes down every 27 minutes with warning "too many missed beacons".Close to the repeater is a client-PC, which is roamed to the parent, and this one has a signal of 63%.The repeater has an...

Recently we've noticed an increase in ad hoc networks in our buildings, likely a result of new laptops with the internal Intel wireless connections that make it so easy. I'm wondering, can these ad hoc networks cause inteference with our WLAN? These ...

I am trying to find a white paper on Redundant WDS (layer 2, 1200 series AP) but having no luck. I am pretty sure you are able to have a redundant WDS but just want to clearify with a white paper. Any URLs?

I am using a 1200 AP in a clinical area for wireless access. It only runs 802.11b. I have about 25 clients in this area connected all the time. We just went live with this yesterday and the wireless devices keep dropping the connection to the AP. Is ...

I am trying to configure AP 1200 MAC adress filters in allowing a list of MAC addresses, but the list is not being applied. How can I configure the restriction "deny any" in a AP 1200, so I can deny any MAC address but the ones allowed in my list.

Anyone done any comparisons between different types of 2.4 Ghz rubber duckies - Specifically the 2dBi Cisco AIR-ANT4941 and something with (supposedly) higher gain like the Linksys HGA7T? If so, I'd appreciate hearing about your findings. THANKS

Hi,can anybody guide me on how to find config info about setting up a 871 as a hotspot wlan?I have found these references, but would like to find more info:http://www.cisco.com/en/US/products/hw/routers/ps380/products_data_sheet0900aecd8016ef57.htmlh...

We have upgrade our APs 1100 from Firmware 123-2.JA2 to new 123-4.JA.We are using wireless with 7920 (firmware 2.0) and CCM (4.1.3 sr1); after the upgrade we have problems with roaming !!

I have a 1220B Access Point and do not know what the default login is, or how to set back to factory defaults.Any help \ suggestions would be appreciated.Regards,John Veliss

I have inherited a network running the 1220. Since I have no documentation from the previous admin and no passwords, I can't secure the network as long as this device is enabled. I have since disconnected it and would like to reconfigure from the gro...