Fatal error on ap1200

[james_d]

I used a new ap1200 with an 11.42 image on it and tried downloading an config file to it from a file taken from an ap1200 point with 12.00T image. I got the following message: 2097/01/10 01:01:01 (FATAL): Radio Enable Failed with error "Bad

Authentication Type". Temporarily Disabling WEP Encryption and re-Attempting

Enable. THIS ERROR MAY INDICATE TAMPERING WITH THE RADIO AND/OR ITS ENCRYPTION

KEYS!

I get the line (Auto Apply On) :BOttom, :Down, ^R, =, <ENTER>, or [Link Text]:

but cannot enter a command. There is no reset button on the new ap1200, what can I do to reset to factory default?

Jim D.

[tepatel]

Plug the console to AP1200 and here is the link for procedure to bing it back to factory default config.

http://www.cisco.com/warp/public/102/wlan/pwrec-2.html#resetap

[james_d]

I have tried the proceedure and after the 3 messages of "Fatal" and the prompt I entered the :resetall command. There is no response other than a representation of the "(Auto Apply On) :BOttom, :Down, ^R, =, , or [Link Text]:" Is there any other proceedure you are aware of that would reset to default?

Thanks - Jim D.

[tepatel]

You need to enter that :resetall command during that 2 minutes from initial power on, and right after Summary Status screen reappears.

Do you see summary screen appeared at all?

You can post console log from power on here.

[jwellner]

Jim

You have WEP enabled but do not have a WEP key. Enter a WEP key and this message will go away.

Jack