601
Views
0
Helpful
1
Replies
Firewall see Controller IP instead of client IP
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-23-2017 12:04 PM - edited 07-05-2021 07:45 AM
WLC is setup as a DHCP server for a specific SSDI/VLAN. My firewall list the IP of the controller instead of the client.
Can I change that so the firewall see the client IP so I can apply rules ?
Labels:
- Labels:
-
Wireless LAN Controller
1 Reply 1
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-23-2017 11:58 PM
I'm a bit confused about your request. Do you see in the firewall the DHCP package or the normal traffic from the WLC?
If you have set the WLC in the DHCP options as the primary gateway, it will route and thus would be visible in your firewall as the source IP. If your primary gateway is your firewall or any other device, which is reachable through your firewall, then you should see the client IP addresses.
If you have set the WLC in the DHCP options as the primary gateway, it will route and thus would be visible in your firewall as the source IP. If your primary gateway is your firewall or any other device, which is reachable through your firewall, then you should see the client IP addresses.
