06-22-2013 08:04 AM - edited 07-04-2021 12:16 AM
Hi all ...
I Use AP 1260 in our warehouse which is used with one Mobility Device "PDA Scanner " but once its connected I Have one Error , then I must change the IP address to That Device to reconnect
Packet to client [characters] reached max retries, removing the clien
I change the Channel between all the Aceess Point and I change the Max Data Rate and Retries to 128 but it still the same shall I do Upgrade for AP from 12.4 to 15.2
Please advise on this Matter
06-23-2013 08:32 PM
Post your configuration so we may review.
Sent from Cisco Technical Support iPhone App
06-25-2013 09:23 PM
Hello Adnan,
This error message indicates that the access point attempts to poll the client a certain number of times, but does not receive a response. Therefore, the client is removed from the association table. This issue is commonly seen when the client and access point are attempting to communicate in a noisy RF environment.
To resolve this issue, run a carrier busy test on the access point to determine if there is excessive noise in the radio channel spectrum. Attempt to alleviate any unwanted noise.
If there are several access points in the same area, there might be overlapping the channel signals or possibly other wireless device in the area. Change the access point channel to one of the non-overlapping channels using the access point GUI. Under Network Interfaces, select Radio-802.11. There are three non-overlapping channels: 1, 6, and 11.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide